I had some time to spare so I started another nessi. This one is a bit bigger than the last one (22 cm in total) . I copied the shape from the last one and lengthened it a bit and then rough cut it out with an angle grinder
About 20 minutes later and a 80 grit belt on the grinder
not a very good picture ,but the bevels are now done . 22 degree zero ground scandi bevels . some people don't zero grind before heat treatment , but I haven't had any problems as long as the quench oil is hot
Holes drilled and countersunk a bit to get rid of any sharp bits . I should get to do the heat treatment tomorrow if all goes well
No comments:
Post a Comment